Rock in driftwood stump

© Peter Mitchell

RV Trailer 10

Second coat of white is done and the first coat of yellow has been added.

© Peter Mitchell

 Some more painting inside of the storage area that will be under the bed platform. Walls are being finished with varathane.

© Peter Mitchell

 Second coat of yellow is done and the masking tape removed.

© Peter Mitchell

Ceiling has been primed and one coat of paint done. One more coat to do on the ceiling.

© Peter Mitchell

RV Trailer 9

Adding fibreglass to the outside.

© Peter Mitchell

 Fibreglassing finished.

© Peter Mitchell

Starting the first coat of primer.

© Peter Mitchell

 First coat of primer done.

© Peter Mitchell

 Second coat of primer done.

© Peter Mitchell

 First finish coat done on the front, an off white. At the back you can see a line and the primer where we will be painting a bright yellow. (After we finish two coats of the off white.)

© Peter Mitchell

RV Trailer 8

© Peter Mitchell

 Started the wiring.

© Peter Mitchell

© Peter Mitchell

Part of the bed platform put into place.

© Peter Mitchell

And the outside sheathing is all in place now.

© Peter Mitchell

© Peter Mitchell

Savary Island

© Peter Mitchell

Took a break from the trailer work today and went to Savary Island. Beautiful day out on the beach, nice for swimming, and we were there early enough to get this driftwood shelter to use for shade.

RV Trailer 7

© Peter Mitchell

Started adding the rigid foam insulation on the roof, two layers of 1/2", with wood added along the edge between the cross pieces. The photo below shows the edge piece with some temporary cross pieces screwed on to hold the rigid foam in place on the curve until we get the outside sheathing on.

© Peter Mitchell

 From the front with just one layer of foam insulation and not held down yet.

© Peter Mitchell

 Also started preparing the inside back storage area for priming and painting. The bed platform is pulled out of the way to make this step easier.

© Peter Mitchell

RV Trailer 6

© Peter Mitchell

The inner layer for the roof installed with cross pieces to provide support. Plan to use two layers of 1/2" rigid foam which should bend nicely to follow the curve of the roof.

© Peter Mitchell

Used these scraps to push up on the 1/8" plywood under each cross piece while the glue dried. Actually glued the first couple but then changed to use epoxy.

© Peter Mitchell

We have build out the front. This shows the inner layer of 1/8" plywood tacked down.

© Peter Mitchell

This is the inside of the front.

© Peter Mitchell

This is the back passenger side storage compartment where we will put the cooler style fridge, showing the tray on sliders.